Delphi II DL-00035 Medical Alarms User Manual


  Open as PDF
of 40
 
DL-00035 Rev. 4
15
Measuring Pulse Oximetry
The monitor will display the following instructions to apply the pulse oximetry
sensor and take a pulse oximetry measurement:
1. Place the finger sensor on your middle or index finger. If the blood pressure
cuff is also in use, do not apply the finger sensor and blood pressure cuff to
the same arm.
2. Fit the sensor as shown on the screen.
Whenready,press“TakeMeasurement”andremainstilluntilthemeasurement
iscomplete.Whenfinished,themeasurementwillbedisplayedonthescreen.
If you receive any error codes while taking measurements, follow the instructions
on the screen and contact your clinician.
Measuring Temperature
The monitor will display the following instructions to use the temperature probe
and take a temperature reading:
1. Put the tip into a new disposable plastic cover, if one is available.
If you do not have a plastic cover, clean the pointed end (probe)
with soap and warm water or rubbing alcohol. Rinse it with cool water.
2. Withyourmouthopen,putthecoveredtipunderyourtongue.
3. Close your lips gently around the temperature probe.
Whenready,press“TakeMeasurement”andremainstilluntilthemeasurement
iscomplete.Whenfinished,themeasurementwillbedisplayedonthescreen.
If you receive any error codes while taking measurements, follow the instructions
on the screen and contact your clinician.
 previous next