Filter
Top Products
- Eng 15 -
English
2)Then, push the POWER/MEASURE switch momentarily to display the measure screen.
* If the POWER/MEASURE switch is pushed and held for a while (about 1 second),
the power is turned off. When displaying the measure screen while the power is
turned on, push and release the POWER/MEASURE switch quickly.
*To change the basal body temperature recording mode ( LADY is displayed) to
the all-measurements recording display ( LADY is not displayed), repeat the opera-
tion of “Setting alarm, time, date, and mode” (on pages 6-10) from the first, then
select the all-measurements recording mode.
3)Place the sensor of the probe under your tongue to start measurement. If peeps are
heard, the measurement is in error (“E” is displayed). In this case, push the POWER/
MEASURE switch again and start measurement.
4)A pip is heard. When more pips are heard about 5
minutes after measurement is started, measure-
ment is finished.
* The first electronic pip indicates that the tempera-
ture is being measured normally.
Ending of
measurement