Filter
Top Products
- Eng 13 -
English
SETTING THE CLOCK
2 Date and time correcting procedure
The alarm time, current time and calendar should be set in the written order.
• Each time you press the “MODE” switch, the data item to be modifi ed changes in the
sequence shown below. The selected item fl ashes on and off.
1. Alarm, minute s 2. Alarm, hours 3. Seconds 4. Minutess 5. Hours 6. Years
7. Months 8. Day of months 9. Time system (12-hour or 24-hour system)
• Press “SET” switch to increase the indicated value in increments of one.
Hold down the “SET” switch on to advance the setting continuously.
• The aforementioned switch performance will not be carried out for the correction of “3)
Second” and “9) Time system (12-hour or 24-hour system).”
• After the completion of correction of all items as required, press “START/STOP” switch
to restore the time indication to the display.
* Date/hour/alarm setting when the batteries are fi rst loaded
into the unit.
Data and time: 12:00 am, January 1, 2007
Alarm: 12:00 am, alarm is in OFF state
1 Initial state. (When you load the batteries in the unit for the fi rst time,
carry out the reset procedure.)
MODE Switch
SET Switch
MEMORY Switch
START/STOP
Switch
a Stand-by
Date display
Time display