Filter
Top Products
SKU 44006 For technical questions, please call 1-800-444-3353. Page 5
MOUNTING
Note: Before use, attach your hoist to
an overhead pipe using the included
brackets as follows:
1. Find the 2 Fixing Rings (#3) and the
Hex Head Bolts (#4).
2.
Figure 1. Mounting the Hoist.
Place the Fixing Rings over a suitable
pipe, in the position you wish to
mount the hoist.
3. Have an assistant hold the hoist
in place while you install the Bolts
through the Fixing Rings into the
threaded holes in the Fixing Rack (#1)
of the hoist.
4. With the hoist in the correct position,
rmly tighten the bolts.
Figure 2. Optional Pole Mount.
Note: Your hoist may be mounted on a
xed overhead pipe, or attached to a
pole on a rotating pillar.
OPERATION
1. The cable spool will not turn freely.
To pull out or wind up cable, you must
operate the power switch.
2. To operate the power switch, take the
Handle Base in your hand. Press the
upper part of the rocker Switch to reel
in the cable. Press the lower part of
the rocker cable to reel out cable.
3. Check to be sure it is safe to lift or
pull the item.
4. To pull out the cable, grasp the lift
hook, and pull it away from the hoist
while pressing the lower part of the
power Switch . Always leave at least
three turns of cable on the spool to
prevent pulling the cable out of the
Hoist.
5. Attach the cable rmly to the item
using the lift hook or pulley lift hook.
Never wrap the cable around the
object and hook onto the cable itself.
This can cause damage to the ob-
REV 02a