Filter
Top Products
10
OPERATING YOUR BREVILLE KINETIX
®
CONTROL
Step 4
Plug power cord into a 230/240V power
outlet and switch on.
Step 5
Press the ‘Power’ button
on the far left
of the control panel to turn the blender
on. The ‘Power’ button will illuminate and
flash. The LCD timer screen will illuminate
with ‘00’ displayed.
NOTE
Do not fill the blender jug above the
‘MAX’ line. When the blender jug is filled
at or near the ‘MAX’ line place one hand
on the blender lid to avoid displacement
of the lid during operation.
Step 6
Select the required speed (1 to 5) by pressing
the corresponding speed button. The blender
will start to operate and the selected speed
button will illuminate. The ‘Power’ button will
illuminate and cease to flash.
The ‘Stop’ button will illuminate and flash.
The LCD timer screen will start counting
upwards in one second increments until 120
seconds is reached.
NOTE
Operate the blender only for the
appropriate amount of time required –
do not over blend.
Step 7
When 120 seconds is reached, the blender
will automatically cease to operate and the
selected speed button and ‘Stop’ button
illumination will go out. The ‘Power’ button
will illuminate and flash. After a few seconds
the LCD timer screen will revert to ‘00’.
NOTE
• The Blender will automatically
stop blending after 120 seconds (2
minutes). This is a safety feature and
restricts wear on the motor.
• To stop blending at any time, press
the ‘Stop’ button or the selected
speed button. The ‘Power’ button
can also be pressed, but this will
also turn the appliance off and all
illuminations will go out.
• The speed can be changed at any
time during the blending process.
Each time a new speed is selected
its button will illuminate and the
previous speed button illumination
will go out. The number of seconds
on the LCD timer screen will
continue to count upwards to 120
seconds unless interrupted.
Step 8
The Breville Blender features two additional
pre programmed functions, ‘ICE CRUSH’
and ‘SMOOTHIE’ and a 'PULSE' function.
These two pre-programmed cycles
automatically adjust the blending time
and speeds to optimise blending results.
Select the required function by pressing
the corresponding function button. The
blender will start to operate and the selected
function button will illuminate. The ‘Power’
button will illuminate and cease to flash.
The ‘Stop’ button will illuminate and flash.
The LCD timer screen will start counting
backwards in one second increments until
‘00’ is displayed.