Braun NVL SERIES Mobility Aid User Manual


  Open as PDF
of 53
 
Page 48
Maintenance and Lubrication Schedule
Resecure, replace or correct as needed
Use Braun 32840-QT (Exxon
®
Univis HVI 26)
K\GUDXOLFÁXLGdo not mix with Dextron III or other
K\GUDXOLFÁXLGV&KHFNÁXLGOHYHOZLWKplatform
lowered fully and roll stop unfolded fully. Fill
WRZLWKLQßRIWKHERWWRPRIWKHßÀOOWXEH
(neck).
Tighten, repair or replace if needed.
Replace if needed.
Tighten or replace if needed.
Replace damaged parts and lubricate if needed
Replace if needed.
Inspect cotter pins on platform pivot pin (2)
Hydraulic Fluid (Pump) - Check level. Note: Fluid
should be changed if there is visible contamination.
,QVSHFWWKHK\GUDXOLFV\VWHPF\OLQGHUKRVHVÀW-
WLQJVVHDOVHWFIRUOHDNVLIÁXLGOHYHOLVORZ
,QVSHFWF\OLQGHUVÀWWLQJVDQGK\GUDXOLFFRQQHFWLRQV
for wear, damage or leaks
Inspect parallel arms, bushings and pivot pins for
visible wear or damage
Inspect parallel arm pivot pin mounting bolts (8)
Inspect vertical arms, handrails and pivot pins for
visible wear or damage
Inspect upper/lower fold arms, rotating pivot slide
arms, slide support arms and associated pivot pins,
bushings, and bearings for visible wear or damage
4500
Cycles
Perform all procedures listed in previous section also
 previous next