Filter
Top Products
Page 14
Maintenance and Lubrication Schedule
1500
Cycles
750
Cycles
Apply Light Oil - See Lubrication Diagram
Apply Door-Ease - See Lubrication Diagram.
Apply to the surface area around both slots and
wipe off excess.
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Synthetic Grease - See Lubrication
Diagram
Use compressor and nozzle to remove all debris
from housing. Clean outboard lower pan slot
and apply Antisieze to slot before reinstalling
pan.
Use clean cloth and solvent to clean tracks.
Clean outboard lower pan slot and apply Anti-
sieze to slot before reinstalling pan.
Correct or replace damaged parts and/or relubri-
cate. See Drive Chain Adjustment.
Correct or replace damaged parts and/or relu-
bricate.
Ensure T-handle release and cable assembly
operate properly. Ensure carriage can be manu-
ally extended and retracted freely.
Carriage and eccentric shaft rollers (bearings)
Lifting arm slots in rolling horizontal carriage arm
tubes
Hydraulic cylinder pivot points (4 per cylinder)
Drive chain and chain rollers
Drive chain release latch mechanism
Deploy lift, remove inboard and outboard lower
pans and blow out housing. Blow off platform
also.
Deploy lift, remove inboard and outboard lower
pans and clean housing tracks
Check drive chain tensioner, jam nuts and con
necting link for securement and/or misalignment.
Inspect drive chain release latch mechanism for
proper operation, positive securement, wear or
other damage
Inspect platform cable-activated manual release
system (T-handle/cable assembly and carriage
movement)
Inspect lift for rattles
Check drive chain tension.
Inspect inner roll stop and linkage for:
• Proper operation. Roll stop should rest solidly on
floor providing smooth transition.
• Positive securement
• Wear or damage
Check carriage ride height in housing
Check stow height/lifting arm alignment
Inspect wiring harnesses for securement, wear or
other damage
Check lower pan securement
Torque tube pivot bearings (4 places)
Correct as needed.
Pull out and lock manual release cable. Adjust
chain tension as needed. See Drive Chain
Adjustment.
Resecure, replace or correct as needed. See
Inner Roll Stop Adjustment Instructions.
Adjust as needed. See Carriage Ride Height
Adjustment.
Lifting arms should be horizontal, aligned with
each other and aligned with carriage. Adjust as
needed. See Switch Adjustment (Below Stow
Switch).
Resecure, replace or correct as needed
Resecure, replace damaged parts or correct as
needed.
Apply Light Oil - See Lubrication Diagram