Filter
Top Products
Page 9
Inboard Locator Adjustment
3. Remove the 1/4" lock nut se-
curing the lifting arm cam bolt.
See Photos D and E. Do not
remove the bolt.
Raise the platform fully (floor
level) using the manual op-
eration system.
Remove the cam securement
bolt (lift inboard locator to re-
lieve pressure on bolt).
Allow the inboard locator to rest
on the floor.
Rotate the cam so the cam fol-
lower bearing engages the cam
notch (saddle). See Photos F
and G.
Reinstall the cam securement
bolt in one of the three lifting
arm holes that best lines up
with one of the nine holes in the
cam. See Photos F and G.
Reposition the securement bolt
lock nut. Note: Lowering the
platform will allow access to
cam bolt. Tighten securely.
1/4" Lock Nut
Cam Bolt
Cam Notch (Saddle)
Cam
(9 available holes)
Lifting Arm
(3 available holes)
Rocker
Slider Block
Cam Notch (Saddle)
Engaging
Cam Follower Bearing
D
E
F
G
R
o
t
a
t
e
C
a
m
R
o
t
a
t
e
C
a
m
Floor Level and Inboard Locator Adjustments