Filter
Top Products
Page 18
Lift Features (continued)
Pre-Lift Operation Notes and Details
ing the DOWN switch deploys
(unfolds) the roll stop. The roll
stop is cylinder powered to
automatically fold (rotate) to the
vertical position when the UP
switch is pressed (roll stop
raises before platform raises).
Read warning posted on
opposite page. Discontinue
lift operation immediately if
the roll stop does not operate
properly.
Roll Stop Latch: A spring-
loaded latch engages the
outboard roll stop when the roll
stop rotates upward from the
ramp position to the vertical
position (UP switch is pressed
to raise the platform above the
ground). Note: The platform
must raise approximately two
inches before the latch engages
fully (see photos below).
The latch disengages the roll
stop when the platform lowers
fully (reaches ground level) and
Note: Platform must raise
approximately two inches
before latch engages fully.
Outboard Roll Stop
Fully Unfolded Roll Stop (Ramp position) Fully Folded Roll Stop (Up-vertical)
Disengaged
Roll Stop Latch
Fully Engaged
Roll Stop
Latch
2"
Latch Foot