Filter
Top Products
Page 8
The door hinges on ASKO dryers are reversible. The
dryers are shipped left-hinged. To reverse them, follow
the steps below:
REVERSING THE DOOR HINGESREVERSING THE DOOR HINGES
REVERSING THE DOOR HINGESREVERSING THE DOOR HINGES
REVERSING THE DOOR HINGES
WARNING!
Switch off the main power supply
before you start this procedure.
11. Tighten the screws on the sides of the doors to hold
the magnetic catch and cover plate in place.
12. Using a flathead
screwdriver, carefully
remove the plastic
plugs in the upper
and lower edge of the
door and place them
in the empty holes on
the opposite side.
13. Remove the screw in the top right
corner of the bottom panel. (If you
have a condenser dryer, you will have
to open the condenser unit door.)
14. Now you are ready to mount the door on the right
side. Holding the door at an angle (as illustrated),
fit the hinge pin into the top hole.
15. Position the bottom hinge bracket
and secure it with the screws in the
order illustrated at right (a, b, c).
16. Replace the screw you removed
in step 13 (d).
17. Replace the lower panel.
18. Turn back on the main power.
1. Remove the two 20 torx screws on the bottom of
the bottom panel then grasp the bottom of the panel
and pull it forward and down.
2. Remove the bottom hinge
bracket by removing the three
screws holding the bracket in
place.
3. Supporting the door from the
bottom, pull it out and to the left as
you turn the hinge bracket counter-
clockwise.
4. Remove the hinge pin at the top of
the hing bracket.
5. Turn the hinge bracket upside down
and put the hinge pin into the top hole.
6. Transfer the top hinge pin to the right side of the
dryer casing.
7. Loosen the two screws on both outer edges of the
door so you can remove the magnetic door catch
and the cover plate.
8. Remove the magnetic catch
by pushing it up then lifting it
out from the bottom.
9. Remove the cover plate on
the opposite side of the door
by pushing it down then lifting
it out from the top.
10. Reverse steps 8 and 9 to place the door catch and
cover plate into their new positions.
1
2
3
Hinge
pin
a
b
c
d