Filter
Top Products
Page 14
CARE CARE
CARE CARE
CARE
AND MAINTENAND MAINTEN
AND MAINTENAND MAINTEN
AND MAINTEN
ANCE INSTRANCE INSTR
ANCE INSTRANCE INSTR
ANCE INSTR
UCTIONSUCTIONS
UCTIONSUCTIONS
UCTIONS
CLEANING CLEANING
CLEANING CLEANING
CLEANING
THE LINT FILTHE LINT FIL
THE LINT FILTHE LINT FIL
THE LINT FIL
TERTER
TERTER
TER
The wear on fabrics in a tumble dryer is insignificant.
The lint caught in the lint filter is dust and fiber residue
that has been formed when the garments have been
worn. The lint filter must be cleaned after each load. If
this is not done, drying performance will suffer, as
insufficient air will pass through the drum. The machine
may also overheat after a while, which will cause it to
stop automatically.
To clean the lint filter, follow the steps below:
1. Grasp the handle
and pull it toward
you.
2. Remove the filter
from the holder.
3. Open the filter and
gently brush away
any lint.
4. Fold the filter
together and return
it to the holder on
the door.
5. Push the holder in
until it snaps into
place.
NOTE: If you use dryer sheets (not recommended),
you may occasionally need to wash the lint
filter with warm water and a soft brush to clean
any blocked holes.
CLEANING THE CONTROLCLEANING THE CONTROL
CLEANING THE CONTROLCLEANING THE CONTROL
CLEANING THE CONTROL
PP
PP
P
ANELANEL
ANELANEL
ANEL
To clean the control panel, use only a soft, warm, damp
(not wet) cloth. To prevent penetration of water into the
door lock and electrical components, never spray water
or cleaning solvent of any kind on the control panel.
Also, never use abrasive cleaners or scouring pads on
the outer surfaces because they will scratch the finish
and possibly remove the writing on the control panels.
Some paper towels may also scratch the finish.