Filter
Top Products
Page 13
ENGLISHENGLISH
ENGLISHENGLISH
ENGLISH
ERRERR
ERRERR
ERR
OR MESSAOR MESSA
OR MESSAOR MESSA
OR MESSA
GESGES
GESGES
GES
Error messages will display on the LED if a fault occurs
while a program is in progress. The table below defines
each possible error message. If the message still
displays after you have checked the possible solutions,
call a service technician.
MESSAGE ERROR
F1 Call a service technician.
F2 There may have been a power outage. Check the breaker box and fuses.
The dryer is programmed to stop after a maximum of 3 hours drying time. If it has run this long,
let it cool and try to start the program again.
Try turning the power off then on again. If the message remains, call a service technician.
F3 This indicates a thermistor fault. Call a service technician.
F4 This indicates the overheat protection device has activated. Clean the lint filter and try running
the program again.
F5 This indicates a fault in the moisture sensor. Running a dry program with dry clothes or an
empty machine could also cause this error. Try opening the door. If the message remains, call a
service technician.
SIGNAL
Press this button to set a signal to sound for three
seconds when a program is complete. The indicator
light will stay lit when this option is on.
If you selected the Wrinkle-free option, the signal will
sound every time the drum rotates.
QUICK COOL-DOWN
Every program, except Air Fluff, ends with a cool-down
cycle that tumbles the clothes without heat to reduce
wrinkling. The Cool-down button lets you choose
between the Normal cool-down cycle (15 minutes) or a
Quick cool-down cycle (5 minutes). The indicator light
will stay lit when Quick is selected.
CHANGING OPTION SETTINGSCHANGING OPTION SETTINGS
CHANGING OPTION SETTINGSCHANGING OPTION SETTINGS
CHANGING OPTION SETTINGS
You cannot change the option settings after you have
pressed Start. To change a setting, hold down the Stop
button until the unit stops, make your change, then press
Start again. The program will restart from the beginning.
PRPR
PRPR
PR
OGRAM MEMOROGRAM MEMOR
OGRAM MEMOROGRAM MEMOR
OGRAM MEMOR
YY
YY
Y
The dryer is designed to retain the settings last selected
with each program. For example, if you select Normal,
the Low temperature option, a 2-hour anti-crease, and
Quick cool-down, next time you select Normal these
options will automatically be selected.
CHILD-SAFE STCHILD-SAFE ST
CHILD-SAFE STCHILD-SAFE ST
CHILD-SAFE ST
ARAR
ARAR
AR
T FEAT FEA
T FEAT FEA
T FEA
TURETURE
TURETURE
TURE
You can program the dryer not to start unless the Start
button is held down for three seconds. This is to prevent
children from inadvertently starting the machine. To
program this function, follow the steps below:
1. Turn the machine off then on again. (“00” should show
on the LED.)
2. Press the Start button five times in succession then
press the Wrinkle-free button five times. (This must
be done within 15 seconds.)
3. Within three seconds, press the Wrinkle-free button
again to select Child-safe start. The LED will display
“3” to indicate the Child-safe start is active. (If the
child-safe start has already been activated, “0” will
display after you press the Wrinkle-free button.)