A&D HW-100KV-WP Scale User Manual


 
Page 44 HV-WP/HW-WP Series
15. The Function Table
15.2.
15.2.15.2.
15.2. Parameter List
Parameter ListParameter List
Parameter List
Item Display Meaning and purpose
Turns the display OFF automatically.
f1 0
No automatic display OFF
Automatic
display
OFF
f1 1
Automatic display OFF
Selects the way of changing weighing range for HV-WP series.
f2 0 # Automatic range
Weighing
range
f2 1
Manual range using the RANGE switch.
Selection of the first unit at the time when the scale turns on.
f3 0 #kg
f3 1
lb
f3 2
oz
Unit
f3 3
lb-oz
Transmission rate of the serial interface (RS-232C/ 422/485).
f4 0 # 2400bps
f4 1
4800bps
Baud rate
f4 2
9600bps
Mode selection for the serial interface (RS-232C/ 422/485).
f5 0 # Stream mode. (Refer to "16.2 Stream Mode")
f5 1
Command mode. (Refer to "16.3 Command Mode")
f5 2
Data is output, when the PRINT switch is pressed.
f5 3
Auto-print +
When the display becomes a positive stable value without nearly-
zero, the scale outputs the data automatically. Next output can be
performed after the display becomes nearly-zero or a negative value.
f5 4
Auto-print +/-
When the display becomes a stable value without nearly-zero,
the scale outputs the data automatically. Next output can be
performed after the display becomes nearly-zero.
Output
mode
f5 5
At each finish of full/dribble batch function, the data is output.
f6 0 #
Pressing the SET switch, the scale always compares the current
display value.
A
A
f6 1
The scale always compares the display value.
A
f6 2
Pressing the SET switch, the scale always compares the display
value when not nearly-zero.
A
A
f6 3
The scale always compares the display value when not nearly-
zero.
A
Comparator
f6 4
When the display value becomes stable after pressing the
SET
switch, the
scale compares the display value. It does not compare on an unstable
condition. If the
SET
switch is pressed again, the scale stops the comparison.
The "#" is factory settings. The "nearly-zero" is within ±4 digits from zero point in the unit of kg.