A&D HW-100KV-WP Scale User Manual


 
HV-WP/HW-WP Series Page 43
15. The Function Table
15.
15.15.
15. The Function Table
The Function TableThe Function Table
The Function Table
The function table is the function to store and refer items that determine the
performance of the scale. Each item has a parameter.
The parameters are maintained even without power applied.
15.1.
15.1.15.1.
15.1. The Procedure
The ProcedureThe Procedure
The Procedure f
f f
for
oror
or Setting Parameters
Setting Parameters Setting Parameters
Setting Parameters
Step 1 Turn off the display.
Press the ON/OFF switch while the ZERO switch is
pressed and held. The function table is displayed.
Step 2 Set parameters for each item using the following
switches.
switch Selecting the parameter of an item.
Selecting the number of a figure at f16.
switch Selecting a figure at f16..
F switch Proceeding to the end of the table
without storing the parameter.
ENTER switch Storing a parameter for the current item
and proceeding to the next item.
Returning to normal mode from the end
of the table.
Step 3 Press the
ENTER switch to return to the normal mode,
when end is displayed.
Note Pressing the ENTER switch at step 2, the parameter is
stored in the scale.