Filter
Top Products
15
Desired Sample Size Not Using The SAMPLE Key
1. The three UNIT WEIGHT BY LED’s should be blinking at this
point, if not, press the RESET key. to clear any unit weight. If you
are going to use a tare container, place it on the weighing pan and
press the TARE key. Be sure to set the weight display is “0”.
2. Place sample pieces on the
weighing pan (or in the tared
container).
The weight of the pieces will be
displayed.
3. Use the
0 Æ 9 10-key pad to
enter the sample size of the pieces
you placed.
If you hit the wrong key, press
the C key to clear and enter again.
(Example of setting a sample size of
20)
4. Press the ENTER key.
The display will show “-------” for a
moment while calculating the unit
weight. After a moment the display will
show the count, total weight and unit
weight.
If the “add ##” display appears on the
unit weight display, then the sample
size is not large enough for accurate
counting – add the additional number of
sample pieces.
5. You may now begin counting operations
for pieces of the same weight.
888.8.8.810
COUN
T
WEIGHT UNIT
WEIGHT
8
880.000
8
8
0.000000
00
If weight isn’t zero, press the TARE.
TA R
E
888.8.8.820
COUN
T
WEIGHT UNIT WEIGHT
8
880.112
8
8
0.000000
00
888.8.8.820
COUN
T
WEIGHT UNIT
WEIGHT
8
880.112
8
8
add000
ÑBlinkingÒ
ENTE
R
8-------
COUN
T
WEIGHT UNIT
WEIGHT
8
880.112
8
8
add000
888.8.8.820
COUN
T
WEIGHT UNIT
WEIGHT
8
880.112
8
8
5.61200