Filter
Top Products
12
7-6. Weight display resolution
The FS-i series has three kinds of weight display resolution, NORMAL, HIGH and
HIGHER. The following is about “kg” and “lb” display for reference. See the “12.
SPECIFICATIONS” in detail.
NORMAL: 1/3,000
HIGH: 1/6,000 ~ 1/7,500 (depending on capacity)
HIGHER: 1/12,000 ~ 1/15,000 (depending on capacity)
The factory setting is the NORMAL resolution, but it is possible to change by Function
“F2”. Set this function according to the application.
The resolution of the Legal for Trade Models is fixed to NORMAL, and the
setting F2 cannot be changed.
7-7. Simplified operation mode
If desired, the FS-i scale can be set in a Simplified Operation Mode. There are two
kinds of mode according to the Function F14-1 and F14-2. In this mode, the following
keys are active.
f14-1:
Set the upper/lower limits in the setting F14-0 fist and change it to F14-1. Then,
the target weight only can be set using the SAMPLE key. This setting will be
used with Function F7-1 or F7-2.
f14-2:
Set the target weight and upper/lower limits in the setting F14-0, and change it
to F14-2. Then, The settings can not be changed accidentally.
Be sure to set the Function F3 (weighing unit to be used) and F16 (analog
sweep display mode) together with the setting above. Because the weighing
unit and analog display cannot be changed in the simplified operation mode.
7-8. LCD backlight
The Function F17 controls how the LCD backlight turns off. If F17-2 or F17-3 is
selected, the backlight will automatically turn off after the weight display continues to
be stable for 30 or 60 seconds. It will turn on when the weight changes more than 4d
(d=
minimum display division) or any key operation is pressed.