![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/a/8c/a8cda98f-ceeb-46f1-9752-931dc4387f55/a8cda98f-ceeb-46f1-9752-931dc4387f55-bg5d.png)
3 - 28
INSP
ADJ
REAR BRAKE ADJUSTMENT/
FRONT BRAKE PAD INSPECTION AND REPLACEMENT
EC364002
REAR BRAKE ADJUSTMENT
1. Check:
● Brake pedal height a
Out of specification → Adjust.
Brake pedal height a:
5 mm (0.20 in)
2. Adjust:
● Brake pedal height
Pedal height adjustment steps:
● Loosen the locknut 1.
● Turn the adjusting nut 2 until the pedal
height a is within specified height.
● Tighten the locknut.
WARNING
● Adjust the pedal height between the
maximum Å and the minimum ı as
shown. (In this adjustment, the bolt 3
end b should protrude out of the
threaded portion 4 but not be less than
2 mm (0.08 in) c away from the brake
pedal 5).
● After the pedal height adjustment, make
sure that the rear brake does not drag.
Å
ı
EC365080
FRONT BRAKE PAD INSPECTION AND
REPLACEMENT
1. Inspect:
● Brake pad thickness a
Out of specification → Replace as a
set.
2. Replace:
● Brake pad
Brake pad thickness a:
Standard <Limit>
4.4 mm (0.17 in) 1.0 mm (0.04 in)
Brake pad replacement steps:
● Remove the pad pin plug 1.