4 - 80
ENG
AC MAGNETO AND STARTER CLUTCH
2. Install:
● Holder 1
● Bolt 2
NOTE:
● Pass the pick-up coil lead 3 and AC mag-
neto lead 4 under the holder as shown.
● Take care not to catch the AC magneto lead
between crankcase cover ribs.
● Apply the sealant to the grommet of the AC
magneto lead.
Quick gasket
:
ACC-QUICK-GS-KT
YAMAHA Bond No. 1215:
90890-85505
T
R
.
.
7 Nm (0.7 m · kg, 5.1 ft · lb)
3. Install:
● Plain washer 1
● Bearing 2
● Starter clutch drive gear 3
● Starter clutch 4
NOTE:
Apply the engine oil on the plain washer, bear-
ing and starter clutch drive gear inner circum-
ference.
4. Install:
● Woodruff key 1
● Rotor 2
NOTE:
● Clean the tapered portions of the crankshaft
and rotor.
● When installing the woodruff key, make sure
that its flat surface a is in parallel with the
crankshaft center line b.
● When installing the rotor, align the keyway c
of the rotor with the woodruff key.
c
2
1
1
b
a
