GL-1010 Administrator’s Guide 5
then automatically reboots. This does not apply to the controller
that does not have a Token Ring NIC.
Network Configuration
After the GL-1010 controller and digital copier hardware have
been properly installed by service technician, you can locally
configure the controller software, if necessary.
Using the copier’s LCD Touch Screen, you can perform the
following administrative functions:
n Set the TCP/IP addressing mode to employ DHCP services or
manually enter the addressing information.
n Enter the primary and secondary WINS servers’ IP
Addresses.
n Enable or disable the IPX/SPX protocol and set the
appropriate Frame Type.
n Enable or disable NetBEUI.
n Enable or disable the AppleTalk protocol and enter an
AppleTalk name and zone (Ethernet only).
n Set the Token Ring speed.
n Set the Device Name and Workgroup.
Web-based Administration
The embedded web administration tool, TopAccess, allows you
to set up the Print Services applicable to your network from an
administrator workstation using your Internet browser.
Additionally, TopAccess provides access to job monitoring and
system management functions.
Print Mode Setup
Depending on the type of printer your GL-1010 will function as,
specific administrative functions may be required prior to
establishing print services. For example, you may have to set up
Novell printer and server objects.
Client Software Installation
After completing installation to this point, your Network
Document Processing system will be fully functional; however,
you will not be able to print to the digital copier from a remote,
NOTE:
Many of these settings
can also be adjusted from a
remote workstation by
using the TopAccess
application.
