SWITCH COMBINATION FUNCTIONS
Several additional functions can be achieved by pressing the control panel buttons in
combinations.
I
F 4 S c f c p
Flat feed
This ptinter can load paper either from the front slot of from the flat feed slot.
It is recommended to use the flat feed for thick paper or the enveloPes.
Before you load paper from the flat feed slot, it is necessary to indicate the printer that the
paper will be fed by the fiat feed with the following procedure:
1.
2.
3.
4.
the I ON
I button to set the printer off-line.
press the ~ ON
J button again and hold it down.
While holding down the I
ON
[ button down, press and hold the I
1
button.
Continue holding these two button down. In a few second, you will hear a short beep
tone signaling that the flat feed mode is selected.
If youhold thesebuttonsafter theshortbeep tone,youwillhear two beep tonessignaling
that the flat feed mode is cancelled.
Release these buttons, and load paper from the flat feed slot.
Form feed
When you want to eject the current paper, follow the procedures below instead of pressing
the I
] button several times:
1. Press the I ON
] button to set the printer off-line.
2. Press the ~LINEFEED\ button and hold it down. The printer will start performing
successive line feeds.
3. While holding the I
[ button down, press the I ON [ button, then
release both buttons at the same time. The printer will smoothly eject the current page.
22
