Chapter 4: V-Switch Configuration 61
10224
212.199.43.56
Figure 28. Ethernet Port 1 IP Address
Checking the IP Configurations
After setting the management and network port IP addresses, you can use
the CLI command ip config show to access the IP Configuration Table
and view all assigned port IP addresses.
ip config show
Table 13: V-Switch IP Configuration Table
If Name IP Address Net Mask Activity
mgmt 212.199.43.46 255.255.255.0 Active
eth1 212.199.43.56 255.255.255.0 Active
eth1 212.199.43.57 255.255.255.0 Inactive
eth2 212.199.75.66 255.255.255.0 Active
eth3 212.199.12.67 255.255.255.0 Inactive
eth3 212.199.12.70 255.255.255.0 Active
10225
212.199.12.67
212.199.12.70
212.199.75.66212.199.43.46
212.199.43.56
212.199.43.57
Figure 29. V-Switch IP Adresses
Removing an IP Address
An IP address that
has a portal
configured on it
cannot be removed.
Network ports can have multiple IP addresses. You can remove an IP
address that is no longer relevant from a network port using the CLI
command ip config remove. You can remove the last network IP
address from a port, but you cannot remove the management IP address
from Eth1. If you are working in a cluster, the IP address must be
removed from both V-Switch databases. For more information on V-
Switch clusters, see “Introduction to V-Switch Clusters,” page 72.
