278 SANRAD V-Switch User Manual
storage show
Table 73: Storage Disks as seen through V-Switch 1
Alias Entity Name LUN Oper. Status Subdisk
Stor_1 2000002037f88fb8 0 Enabled entire
Stor_2 500507606058c90 0 Enabled entire
Stor_3 2000002037c32b1f 0 Enabled entire
Use the unique disk
entity names (WWUIs)
and NOT the default
disk aliases to
duplicate virtual
volume hierarchies in
each V-Switch.
Stor_4 2000002037c32450 0 Enabled entire
Use the CLI command storage show to list the system-registered storage
devices on VSwitch2. This ensures that all disks were registered during the disk
auto-discovery scan. This also lists the default disk aliases needed for creating
your simple volumes.
storage show
Table 74: Storage Disks as seen through V-Switch 2
Alias Entity Name LUN Oper. Status Subdisk
Stor_1 5005076006058c90 0 Enabled entire
Stor_2 2000002037f88fb8 0 Enabled entire
Stor_3 2000002037c32b1f 0 Enabled entire
Use the unique disk
entity names (WWUIs)
and NOT the default
disk aliases to
duplicate virtual
volume hierarchies in
each V-Switch.
Stor_4 2000002037c32450 0 Enabled entire
Compare this disk table with the disk table from VSwitch1. Note that Default
storage 1 and 2 are reversed in the disk table from VSwitch2. That is, Default
storage 1 in VSwitch1 is listed as Default storage 2 in VSwitch2. You will use
the WWUIs to duplicate virtual volume hierarchies in each V-Switch.
STEP 16. CREATE SIMPLE VOLUMES ON V-SWITCH 1
Use the CLI command volume create simple to create four simple
virtual volumes – one from each physical disk.
volume create simple –vol Simple1 –d Stor_1
volume create simple –vol Simple2 –d Stor_2
volume create simple –vol Simple3 –d Stor_3
volume create simple –vol Simple4 –d Stor_4
STEP 17. C
REATE MIRRORED VOLUMES (RAID 0)
Use the CLI command volume create mirror to create a mirrored
volume, Mirror1, from simple volumes Simple1 and Simple2.
