Call Functions 24
Putting a Call on Hold
You can place the current call on hold whenever you want. You can also make another call while you have a call in
progress if your network supports this service.
To place a call on hold:
1. Press Options ➔ Hold, then press the Select soft key or the key.
2. You can reactivate the call whenever you want, by pressing Resume.
To make a new call while you have a call in progress:
1. Enter the phone number that you wish to dial or look it up in the Contact list.
2. Press the key to dial the second call.
The first call is automatically put on hold.
– or –
Press Options, select New call and press . This places the currently active call on hold and allows to
make a new call.
3. Make the second call in the normal way.
When you have both an active call and a call on hold, you may switch between the two calls by placing the current
held call to active and then placing the other on hold.
To switch between the two calls:
1. Press Options ➔ Swap. The current active call is placed on hold and the call on hold is then reactivated so
that you can continue conversing with that person.
2. To finish, end each call normally by pressing the key.
Using the Speakerphone
While on a call, you can use your Speakerphone by following these steps:
1. Press Spkr on.
2. Press Spkr off to turn the Speakerphone off.
t119.book Page 24 Wednesday, December 10, 2008 3:24 PM
