![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/a/6c/a6c73a07-6d7a-45f5-a7ca-106a4bb5216c/a6c73a07-6d7a-45f5-a7ca-106a4bb5216c-bg72.png)
troubleshooting
Symptom Explanation/Solution
The actual recording time
is less than the estimated
recording time.
• The estimated recording time is calculated by some
references.
• When you record an object that moves fast, the actual
recording time may be shortened.
The recording stops
automatically.
• The internal temperature of your camcorder is extremely
low. Keep it turned on and wait until it warms up.
• If you make a frequent recording or deletion of files, the
performance of the storage media will deteriorate. In this
case, format the storage media again.
• If you use the memory card with low writing speed, the DVD
camcorder automatically stops recording the movie images
then the corresponding message appears on the LCD
screen.
When recording a subject
illuminated by bright light,
vertical line appears.
• This is not a malfunction.
When the screen is exposed
to direct sunlight during
recording, the screen becomes
red or black for an instant.
• This is not a malfunction.
During recording, the
date/time does not display.
• “Date/Time” is set to “Off.” Set the “Date/Time” to on.
p
age 29
You cannot record a photo
image.
(SC-DX103/DX105 only)
• Set your camcorder to the digital camera record mode.
p
age 30
• Release the lock on the write-protection tab of the memory
card if any.
• The memory card is full. Use a new memory card or format
the memory card.
p
ages 52-54
Or remove unnecessary images.
page 61
• You cannot take photo images on a disc. Set the Storage
mode switch to CARD.
T
here is a time difference
between the point where you
press Recording start/stop
b
utton and the point where
the recorded movie starts/
stops.
• On your camcorder, there may be a slight time delay
between the point when you press Recording start/stop
button and the actual point where the recorded movie
starts/stops. This is not an error.
The aspect ratio (16:9/4:3) of
a movie cannot be changed.
• The aspect ratio of a movie at 16:9 cannot be changed to
4:3.
Síntoma Explicación/Solución
El tiempo de grabación normal
es menor que el tiempo de
grabación estimado.
• El tiempo de grabación estimado se calcula mediante
ciertas referencias.
• Cuando grabe un objeto que se mueva rápidamente, es
posible que se acorte el tiempo de grabación real.
La grabación se detiene
automáticamente.
• La temperatura interna de la videocámara es
extremadamente alta. Manténgala encendida y espere
hasta que se caliente.
• Si graba o borra archivos con frecuencia, se reducirá el
rendimiento de la memoria flash incorporada. En este caso,
formatee de nuevo el soporte de almacenamiento.
• Si utiliza la tarjeta de memoria con una velocidad
de escritura baja, la videocámara con DVD deja
automáticamente de grabar las imágenes de video y
aparece el correspondiente mensaje en la pantalla LCD.
Al grabar un objeto iluminado
con luz brillante, aparece una
línea vertical.
•
Este hecho es normal y no se trata de ningún defecto.
Cuando al grabar la pantalla
esté expuesta a la luz directa
del sol, la pantalla se pone roja
o negra por un instante.
• Este hecho es normal y no se trata de ningún defecto.
Durante la grabación, no
aparece ni la fecha ni la hora.
• “Date/Time” (Fecha/Hora) está definido en “Off”. Active
“D
ate/Time” (Fecha/Hora).
p
ágina 29
No es posible grabar una
imagen fotográfica.
(sólo SC-DX103/DX105)
• Coloque la videocámara en el modo de grabación de
cámara digital.
p
ágina 30
• Libere el bloqueo de la lengüeta de protección de la tarjeta
de memoria si la tiene.
• La tarjeta de memoria está llena. Utilice una tarjeta de
memoria nueva o formatee la existente.
p
áginas 52-54
O bien elimine las imágenes innecesarias.
página 61
• No puede tomar imágenes fotográficas en un disco.
Coloque el interruptor del Modo de almacenamiento en
CARD.
E
xiste una diferencia de
tiempo entre el punto en el
que se presiona el botón
Iniciar/parar grabación el
punto en el que se inicia/
detiene el video grabado.
• En la videocámara, es posible que exista una ligera
demora entre el punto en el que presiona el botón Iniciar/
parar grabación y el punto real en el que se inicia/detiene
la grabación de video. No se trata de ningún error.
La relación de altura/anchura
(16:9/4:3) del video no se
puede cambiar.
• La relación de altura/anchura del video en 16:9 no se
puede cambiar a 4:3.
solución de problemas
DX100_US_4_DL.indd 108 2008-03-05 ¿ÀÈÄ 1:42:37