Troubleshooting
[ENGLISH 1
+ If yourun intoany problemusingthe camcorder,usethe followingtableto troubleshootthe problem.
+ Ifthese instructionsdo not allowyou to solvethe probIem,take a note of:
• The model and serial numbermarkedonthe bottomof the camcorder.
• Yourwarranty,if applicable.
+ Then contactyour nearestauthorizedservicecenter.
You cannot switch the • Check the battery pack (see page 23)
camcorder on, or the AC power adapter, (see page 22)
Start/Stop does not • Check the POWER, set it to CAMERA.
operate while recording • You have reached the end of the cassette,
• Check the record protection tab on the cassette. (see page 26)
The camcorder goes • Youhave left the camcorder set to STANDBY
off automatically, for more than 5 minutes without using ib(see page 28)
• The battery pack is fully used up,(see page 25)
The battery pack is • The atmospheric temperature is too low, (see page 25)
quickly exhausted, • The battery pack has not been charged fully,(see page 23)
• The battery pack is completely dead, and cannot be recharged,
Use another battery pack.
You cannot eject the • The battery pack is fully used up,
cassette from the • A mechanical fault might have occurred. (see page 68)
compartment,
The DATEmME indicator • The lithium battery is not installed or is fully used up. (see page 21)
flashes more than 2 times
when you set the
camcorder to CAMERA,
The playback picture • The video heads might be dirty, (see page 66)
ispoor.
You cannot operate any • A mechanical fault might have occurred (see page 68),
functions on the camcorder.
A
