21
English
Preparations
IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
Step 1: Inserting batteries into
the remote control
1 Open the battery compartment.
2 Place two batteries (Type R06 or AA) in the
compartment with the correct polarity as
indicated by “+” and “–” symbols.
3 Close the cover.
Using the remote control to operate the
system
1 Point the remote control directly
at the remote sensor (IR) on the
front panel.
2 Select the source you wish to
control by pressing one of the
source select buttons on the
remote control (for example
TAPE1/2, TUNER).
3 Then select the desired function (for example
2;, O or P).
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.
Step 2: Setting the clock
The clock can be set in either 12-hour or 24-
hour mode (“PM 00:00” or “00:00” for
example).
1 The clock can be set in any source mode.
➜ If you have not set the clock, “--:--” will be
shown on the display.
2 Press and hold CLOCK/TIMER until “SELECT
CLOCK OR TIMER” is displayed.
➜ Press O or P to change the display to
“CLOCK”.
➜ Press CLOCK/TIMER again to confirm.
3 Press O or P on the system to set the
hours.
4 Press 1 or ¡ on the system to set the
minutes.
5 Press CLOCK/TIMER to confirm your setting.
The system will store the setting automatically
and go back to its previous status.
➜ The time setting becomes effective.
Note:
–In AUX mode, setting clock using remote control
is not possible.
To exit the setting without storing (in
standby mode)
● Press 9 on the system to exit.
➜ “CANCEL” will appear on the display.
● Press STANDBY ON to exit setting mode and
go into POWER ON mode.
● You can also press DISC, DISC1~3, DISC
CHANGE, OPEN/CLOSE to exit setting
mode and go to disc mode.
● The system will also exit setting mode and go to
TUNER, TAPE or AUX mode when you press
the corresponding source button.
Viewing the clock in any source mode
● When you have set the clock, press CLOCK/
TIMER to view clock. Press DISPLAY on the
system to toggle between 12-hour and 24-hour
modes.
➜ The time will be displayed for 5 seconds and
then the system will go back to its previous
status.
1
3
2
p001-025-FWD798_37_EngA 2006.5.22, 3:36 PM21
