20
English
Basic Functions
Plug and Play (for tuner installation)
Plug and play allows you to store all available
radio stations automatically.
If plug and play has not been installed
1 When you turn on the system, “AUTO
INSTALL- PRESS PLAY” will be displayed.
2 Press 38 on the system to start installation.
➜ “INSTALL” will be displayed and followed by
“TUNER” and then “AUTO SEARCHING”.
➜ PROG will start to flash.
➜ The system will search all radio stations on
the FM band, and then the AM band.
➜ All available radio stations with strong signal
strength will be stored automatically.
➜ The system will stop searching when all
available radio stations are stored or when the
memory for 40 preset radio stations is full.
➜ The first preset radio station will play when
Plug and Play is completed.
Reinstalling plug and play
1 In Standby or demonstration mode, press and
hold 38 on the system until “AUTO
INSTALL-PRESS PLAY” is displayed.
2 Press 38 again to start installation.
➜ All previously stored radio stations will be
replaced.
To exit without storing the plug and play
● Press 7 on the system.
Notes:
– When the power is turned on, the disc tray may
open and close to initialise the system.
– If Plug and Play installation is not completed, it
will be reinitiated the next time you power on the
system.
– If auto-install is not preset, the system will store
the radio station automatically.
– If there is no antenna connected, “CHECK
ANTENNA” will scroll on the display.
Demonstration mode
The system has a demonstration mode that
shows various features offered by the system.
Activating demonstration
● In Standby mode, press and hold STOP 7 for
more than 5 seconds to activate demo mode.
➜ “DEMO ON” is displayed.
➜ Demonstration will begin.
Deactivating demonstration
● Press and hold STOP 7 on the system until
“DEMO OFF” is displayed.
➜ The system will switch to Standby mode.
Note:
– If you don’t deactivate demostration before
switching to Standby mode, the system will enter
the demostration mode after 7 seconds.
– Even if you remove the AC power cord and
reconnect it to the wall socket, the demonstration
will remain off until you activate it again.
p001-025-FWD798_37_EngA 2006.5.22, 3:36 PM20
