E
13
1 INSTALLATION
Attaching an Arm Stand to the Monitor
WARNING
• When attaching the monitor to the mount, use the enclosed screws
and tighten them securely. When reattaching the monitor to the tilt
stand, use the screws that was attached to the monitor.
By not doing so may result in injury or failure of the monitor. To attach the
mount to the monitor, please read the instruction manual of the mount.
• Use a VESA approved arm-stand. The LCD
panel requires 100 mm x 100 mm hole spacing
on the arm mounting pad. The arm-stand should
be able to support an object weighing 13.5 kg.
• In case of using this LCD monitor with an arm-
stand in an office workspace, the arm-stand
shall be chosen and used carefully:
- Use only an approved arm-stand (e.g. GS).
- The arm-stand shall have sufficient stability
(mechanical firmness) to support the weight
of the monitor.
- The arm-stand shall remain in that position
where it is manually moved.
- The arm-stand shall have the ability to tilt the
monitor forward and backward.
- The height of the upper row shall be less
than or equal to 500 mm in relation to
the desk surface when the arm-stand is
in its lowest position.
(1)Lay the LCD monitor as shown below, not scratching the panel.
Remove the tilt loosening the screws. When reattaching the tilt, use the
enclosed screws and fix the tilt to the monitor securely.
Soft Cloth
or Cushion
500 mm
(Example)
100 mm
x
100 mm
• Do your part to conserve energy, turn off the monitor when you
are finished using it.
