18 A-61121 May 1999
7. Enter function code F40 and press Enter. The following message
will be displayed:
Print Head Position
1=Change Head(s) 2=Clean Printer
8. Select 2;a
Please Wait
message will be displayed. When this
message is no longer displayed, open the front cover of the
scanner.
9. Lift the printer out of the printer bracket and place it on the feeder
top cover.
10. With a supplied swab, wipe off the rubber gaskets and the area
around the gaskets.
NOTE: The rubber gaskets can be removed and cleaned.
Periodically, it may be necessary to replace the rubber
gaskets with a new set. Make sure the gaskets are seated
properly before continuing.
11. Wipe off any ink build-up on the rubber wipers.
12. Tilt the Super12 Document Printer, as illustrated, and wipe the flex
cable connectors and splatter guards.
13. When finished, place the Super12 Document Printer into the
desired print location.
14. Close the front cover.
Gaskets
Splatter guards
Wipers
Flex cable connectors
