A-61121 May 1999 15
If either (or both) print cartridges are not seated correctly, one (or
both) of the yellow lights on the flex cable will flash. If this happens,
repeat Steps 7 through 9 until the print cartridges are installed
correctly.
NOTE: The flashing lights on the flex cable correspond with the print
cartridge(s) that is not positioned correctly.
10. When the print cartridges are installed correctly, reinstall the
Super12 Document Printer in the desired print location.
NOTES
• If you are rotating the Super12 Document Printer, be careful not
to twist or strain the flex cable.
• Be sure the plastic strips are removed only from the print
locations you want to print in, from both the transport plate and
belt module. Plastic strips should be left in place for any
unused locations.
11. Close the front cover when the Super12 Document Printer is seated
properly.
12. Perform function code F45 to test the print heads.
