Filename [MX1S_11Editing.fm]
Masterpage:Left+
76 EN
EDITING
Page 76 Saturday, 30 October 2004 16:18
You can use your unit as the source player or as the recording
deck.
NOTE:
When using another recorder as the recording deck, refer to its
instruction manual.
1 Make connections.
A When recording on HDD or DVD deck
1.If another recorder has no S-VIDEO connector, connect the unit’s
[AUDIO/VIDEO INPUT] connectors to the audio/video output
connectors on another recorder.
2.If another recorder has S-VIDEO connector, connect the
[AUDIO INPUT] and [S-VIDEO INPUT] connectors to the audio and
S-video output connectors on another recorder.
● If connecting a unit with an S-VIDEO connector, it is recommended to
use an optional S-Video cable to minimize picture degradation while
editing.
B When recording on VHS deck
1.Connect the unit’s [AUDIO/VIDEO INPUT] connectors to the audio/
video output connectors on another recorder.
2 Press VHS/HDD/DVD SELECT on the unit repeatedly to select
the recording deck.
3 Press CH +/– to select “L-1” when using this unit as the
recording deck.
For HDD/DVD deck
● Set “REAR AUX L-1” to “VIDEO” for the VIDEO input connector, or
“S-VIDEO” for the S-VIDEO input connector, depending on the
connector being used. (
੬ pg. 83)
4 Press REC MODE repeatedly to set the recording mode.
5 Engage the Play mode of the source player.
6 Engage the Record mode of the recording deck.
7 Stop recording on the recording deck, then stop playback on the
source player.
NOTES:
● All necessary cables can be obtained from your dealer.
● When you use this unit as the source player for editing, be sure to set
“SUPERIMPOSE” to “OFF” before starting. (੬ pg. 82)
Edit To Or From Another Recorder
.
Player
Your unit
Another recorder
Recorder
TV receiver
Player
Your unit
Another recorder
Recorder
A When recording on HDD or DVD deck
B When recording on VHS deck
TV receiver
Slide the TV/CABLE/DBS/DVD switch to DVD.
MX1S_00.book Page 76 Saturday, October 30, 2004 4:18 PM
