A Summary of Commands remove
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 555
remove
The remove command places a unit in the manual-out-of-service state.
Synopsis
remove <unit> <number> <immed> <min_delay> [-i] [-n]
rem <unit> <number> <immed> <min_delay> [-i] [-n]
Description
The remove command is used to remove a unit from service when its
temporary state is idle. It changes the permanent state of the unit to manual-
out-of-service (MANOOS). It does not remove a unit that has a temporary
state of busy. If a unit must be interrupted immediately or appears to be stuck
busy, use the rem <unit> <number> <immed> command.
The parameters for the remove command are:
• <unit> — Identifies the unit. The choices are “channel” or “card.”
• <number> —Specifies the channel or card number, a range of channel or
card numbers in the form m-n, or the word all for all the channel or card
numbers. Card numbers are in the form card#[.port#] where port# is a
port of card#. If port# is not given, all ports of the card specified are
removed. If no card number or channel number is given, the system
displays a syntax message.
