A SERVICE OF

logo

17. Remove the Magnetic roller drive gear. The end cap will
keep the bushing in place.
18. Remove the DR. Blade and two screws.
19. Clean out any remaining toner from the hopper. Note the
Dr. Blade seal. It is a sticky substance that can be clean with
alcohol if toner gets on it.
20. Fill through the Mag roller opening with 110g of P2035
toner for the “A” cartridge, 290g for the “X”. There is not a fill
plug in these cartridges.
HP P2035 2055 CARTRIDGE REMANUFACTURING INSTRUCTIONS
3232 West El Segundo Blvd., Hawthorne, California 90250 USA Ph +1 424 675 3300 Fx +1 424 675 3400 techsupport@uninetimaging.com www.uninetimaging.com
© 2009 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not warrant downloaded information.