A SERVICE OF

logo

3. Push the pins out with a jeweler’s screwdriver. With the hole
in this location by just pushing the screwdriver in, the pins will
be pushed out. Remove the pins.
4. Separate the two halves.
5. With a flat head screwdriver, press the drum axle pin out from the inside of the cartridge wall as shown. There is a small shoul-
der visible that the screwdriver should be pressed against. Make sure not to bend or damage the plastic wall and the plastic is
thin and easily damaged. Remove the Axle pin from the outside with flush cutting wire cutters.
HP P2035 2055 CARTRIDGE REMANUFACTURING INSTRUCTIONS
3232 West El Segundo Blvd., Hawthorne, California 90250 USA Ph +1 424 675 3300 Fx +1 424 675 3400 techsupport@uninetimaging.com www.uninetimaging.com
© 2009 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not warrant downloaded information.