EN
Media jams 21
Overview
5
Remove any jammed media from the duplexer by lifting the
green guide. Remove any media and lower the green
guide.
6
On the left side of the fuser, pull down on the green tab,
carefully remove any media, and release the tab.
Note
Repeated jams in the fuser area indicate that the fuser might
not be installed properly. Complete steps 7 through 9 if you
experience repeated jams in the fuser area; otherwise, proceed
to step 10.
7
Press down the large green lever on the right side of the
fuser to ensure that it is in its proper position.
8
On each side of the fuser, rotate the blue levers down
slightly.
9
Rotate the blue levers back up until they snap into place.
10
Slide the duplexer back into the printer unit until it clicks
into place.
11
Close the lower left door.
12
Reinstall the left output tray.
