2-24 Installing the HP JetDirect Print Server Card
10. With the components facing the left edge of the printer, slide
the card assembly into the printer. Align the top and bottom of
the assembly with the top and bottom guide rails located inside
the printer. Press the cards into the slot until the cards are
firmly seated.
CAUTION
The assembly must fit into the guide rails correctly.
Failure to install the assembly correctly may cause
damage to the formatter board or to the MIO
assembly.
11. Secure the assembly to the printer by tightening the remaining
three thumbscrews a little at a time, alternating between each
side until all of the screws are secure.
12. Connect the network cable.
13. Connect the power cord and turn on the printer.
Insertion of two cards into HP LaserJet 4Si/4SiMX
