HP Jetdirect Configuration Page Messages 8-5
Config. Page
Messages
8
CF ERR - LINE TOO
LONG
A line being processed in the TFTP configuration file
was longer than the HP Jetdirect print server could
accept.
CF ERR - MISSING
PARAM
A line in the TFTP configuration file was missing a
required parameter.
CF ERR - TRAP LIST
EXCEEDED
The TFTP configuration file specified too many trap
destination list entries using the “trap-destination:”
keyword.
CF ERR -
UNKNOWN
KEYWORD
A TFTP configuration file line contained an unknown
keyword.
CONFIGURATION
ERROR
The configuration information for the NetWare
functions is not stored correctly on the HP Jetdirect
print server. Rerun the installation software to
reconfigure. If this error persists, there may be a
problem with the HP Jetdirect print server.
CRC ERROR Check the network topology and verify all cable
segments. Check for damaged cables.
DHCP NACK The server has not acknowledged the DHCP request.
Rerun the configuration software to restart the process.
DISCONNECTED The Novell NetWare protocol is disconnected. Check
the server and the print server.
PORT SELECT
DISCONNECTED
The port on the card that was automatically sensed as
having the cable attached.
No cable detected.
DISCONNECTING -
SPX TIMEOUT
The SPX connection to the print server was lost after
the connection had been made. This indicates a
possible network problem, or a problem with the print
server. Make sure all cables and routers are functioning
correctly. Try restarting the print server.
Table 8.2 General HP Jetdirect Messages (2 of 15)
Message Description
0Book-asF01.book Page 5 Tuesday, August 14, 2001 2:06 PM
