Assembly
15
Right Strut
Tighten These Screws
Rear
Fender
#8-32 x 1
5
/8"
Machine Screw
#8-32 x
3
/4"
Machine Screw
• First, insert a #8-32 x 1
5
/8" machine screw through the
hole in the side of the right strut that is closest to the
rear of the vehicle body, as shown .
• Attach an #8-32 acorn nut to the end of the screw,
inside the rear fender. Hand-tighten the acorn nut.
• Then, insert a #8-32 x
3
/4" machine screw through the
hole in the side of the right strut that is towards the front
of the vehicle body, as shown .
• Attach an #8-32 acorn nut to the end of the screw,
inside the rear fender. Hand-tighten the acorn nut.
• Using an adjustable wrench to hold the acorn nuts
inside the rear fender, tighten the screws.
• Tighten the screws in the top of the right strut (inserted
in Step 11) .
• Repeat assembly steps 11 and 12 to assemble the left
strut to the left rear fender of the vehicle body.
12
Strut
Signal
Housing
• Slide a signal housing onto a strut.
• Bend the tab inside the signal housing down.
13
Strut
Signal
Lens Rib
Signal
Housing
Notch
• Align the rib on the signal lens with
the notch in the signal housing.
Fit the lens into the housing.
•Insert a #8 x
3
/4" screw into the lens
and tighten.
• Repeat assembly steps 13 and 14 to assemble the
other signal housing and signal lens to the other strut.
14
Signal
Lens
Signal
Housing
Bend
Tab
Down
Back View
Wheel
1
1
2
2
4
4
3
3
Guide
Guide
Guide
Guide
• Before applying labels to the wheel, wipe it with a clean,
dry cloth to make sure it is free of dirt and oils. Make
sure your hands are clean.
• Apply labels to both sides of the wheel.
IMPORTANT! Labels 1 and 2 are designed to slightly
overlap; and labels 3 and 4 are designed to slightly
overlap. For each side, apply label 1 before applying label
2. Align the edge of label 2 with the guide marks
on label 1. Apply label 3 before applying label 4. Align the
edge of label 4 with the guide marks on label 3.
14
