A SERVICE OF

logo

Open as PDF
next previous
2-3
IPI 100 and IPI 200 Series • Installation
Å
LAN port(IPI201AAPand204AAPonly)—PluganRJ‑45jackintotheLAN
connectortoconnecttoanetwork.TheblinkingyellowLEDindicatesLAN
activity.ThegreenLEDlightstoindicateagoodLANconnection.
Patch (straight-through) cable
Side 1 Side 2
Pin Wire color Pin Wire color
1 White-orange 1 White-orange
2 Orange 2 Orange
3 White-green 3 White-green
4 Blue 4 Blue
5 White-blue 5 White-blue
6 Green 6 Green
7 White-brown 7 White-brown
8 Brown 8 Brown
Crossover cable
Side 1 Side 2
Pin Wire color Pin Wire color
1 White-orange 1 White-green
2 Orange 2 Green
3 White-green 3 White-orange
4 Blue 4 Blue
5 White-blue 5 White-blue
6 Green 6 Orange
7 White-brown 7 White-brown
8 Brown 8 Brown
Clip Down
Side
1
1&2
3&6
4&5
7&8
2345678
Pins
12345678
RJ-45
connector
Twisted
Pairs
b
AAP mounting screws — ThesefourscrewsarepermanentlyattachedtotheIPI’s
faceplate. They are used for mounting the faceplate into another device (such as an
MLC226IPAAP)oramountingframe.
N
Items
c
to
e
apply only to the IPI 201 and IPI 204 models.
c
Power — Connectacablebetweenthe2‑pole,3.5,mmcaptivescrewconnectorand
a12VDC,1Apowersupply(included).
C
The power supply shall not be permanently fixed to the building structure
or similar structures.
The power supply shall not be located within environmental air handling
spaces or within the wall cavity.
The installation shall be in accordance with the applicable provisions of
the NationalElectricalCodeANSI/NFPA70,Article725 and the
CanadianElectricalCode,Part1,Section16.
The power supply is to be located within the same vicinity as the Extron
equipment in an ordinary location, Pollution Degree 2, secured to the
equipment rack within the dedicated closet, podium or desk.
d
Contact Relay — The 2‑pole,3.5,mmcaptivescrewcontact relay connector is used
to control items such as room lighting, window coverings, and door locks. The
contact may be used to control any equipment as long as the contact specifications
of24VDCat1Aarenotexceeded.
e
Audio Out — A3‑pole,3.5mmcaptivescrewconnectorisusedforaudiooutput
connection.Itprovidesa‑10dBVbalancedorunbalancedsignalthatcanbe
connected to local, powered speakers or to any audio or paging system.