RHT10-EN v4.0 4/14
3
Operation
INSTALLING THE GRAPHING SOFTWARE
Install the supplied Windows PC Datalogger Software by placing the supplied program disk in the PC’s CD-ROM
drive. If the installation program does not automatically open and provide on-screen prompts, open and browse the
CD-ROM drive, then find and double-click on the SETUP.EXE file included on the program disk. Follow the
on-screen prompts to complete the installation.
Before running the graphing software, please install the USB Driver software as described in the next section.
INSTALLING THE USB DRIVER
The USB driver for the RHT10 must be installed manually.
1. Browse to the RHT10 software CD (or downloaded program).
2. Navigate to the \Driver\DriverUSBXPRESS folder.
3. Double-click on the USBXPressInstaller.exe program.
4. Follow the defaults to load this driver.
5. Once installed, plug the RHT10 unit into the PCs USB port and start the RHT10 software.
Note: When the RHT10 is connected to the USB port, the battery inside the device is discharged at a higher
rate than normal. To conserve battery life, do not leave the RHT10 connected to the USB port for a prolonged
period of time
