A SERVICE OF

logo

Open as PDF
next previous
63 MS6000-EU-EN V1.4 8/12
Making a Continuity Measurement
To perform a Continuity test, perform the following:
1) Press the
)
)
) key; the
)
)
) indictor appears at the top of the screen.
2) Insert the black lead into the COM banana jack input and the red lead into the V/Ω/C
banana jack input.
3) Connect the red and black leads to the test points. If the resistance value of the tested
points is less than 30 Ω, a beep will sound from the test tool. The screen will resemble the
image in figure 7-4.
Figure 7-4 Continuity Measurement