47 MS6000-EU-EN V1.4 8/12
Press the Save/Recall button to view the Save/Recall main menu.
Options Settings Comments
SetUp (F2) From the main Setup/Recall menu, Press F2 to engage SetUp mode
Source (F1)
Local
USB
Store the current setups to the USB disk or the Local internal memory
of the oscilloscope.
Location (F2) 0 to 9
Specify the memory location in which to store the current waveform
settings or from which to recall the waveform settings.
Save (F3) Complete the saving operation.
Recall (F4)
Recall the oscilloscope settings stored in the location selected in the
Setup field.
Back (F5) Returns you to the Save/Recall main menu
Options Settings Comments
CSV (F3) From the main Setup/Recall menu, Press F3 to engage CSV mode
Source (F1)
CH1
CH2
Select a waveform display to store.
File List (F2)
Close
Open
Open a file to save the waveform in. A USB device must be
connected in order to save the waveform. Close file after saving.
Save (F3) Complete the saving operation.
Recall (F4)
Recall the oscilloscope waveform stored in the location selected in the
Setup field. USB device must be attached and contain saved file
Delete (F5) Delete the highlighted waveform file from the USB device.
See below for waveform menus.
Note: The oscilloscope will save the current settings 5 seconds after the last modification, and it
will recall these settings the next time the oscilloscope is powered ON.
The white waveforms on the menu is the
recall RefA waveform
At most 9 groups of setups can be stored
