
DXS/DWS 3200 Series User Guide
Page 48
Password Recovery
If a password is lost, use the Password Recovery option on the Startup menu. The procedure enables the user to
enter the device once without a password.
To recover a lost password for the local terminal only:
1. From the Startup menu, select “4” and press <Enter>. The password is deleted.
2. To ensure device security, reconfigure passwords for applicable management methods.
WLAN Licence Key
To upgrade a DXS- model into a DWS model with WLAN support, the user must enter a Licence key. The following
section describes the procedures for entering a Licence Key.
As the switch boots, the bootup test first counts the device memory availability and then continues to boot. The fol-
lowing screen is an example of the displayed POST.
The boot process runs approximately 30 seconds.
The auto-boot message that appears at the end of POST (see the last lines) indicates that no problems were
encountered during boot.
To enter a WLAN licence key perform the following:
1. Suspend the startup process by pressing
<Esc> or <Enter> within two seconds and the following message is
displayed:
The Startup Menu is displayed and contains the following configuration functions:
2. From the Startup Menu, press “7”.
------ Performing the Power-On Self Test (POST) ------
UART Channel Loopback Test........................PASS
Testing the System SDRAM..........................PASS
Boot1 Checksum Test...............................PASS
Boot2 Checksum Test...............................PASS
Flash Image Validation Test.......................PASS
BOOT Software Version x.x.x.xx Built 07-Jan-200x 10:53:05
Processor: xxxxxx xxxxx xxxx, xx MByte SDRAM.
I-Cache 8 KB. D-Cache 8 KB. Cache Enabled.
Autoboot in 2 seconds - press RETURN or Esc. to abort and enter prom.
Autoboot in 2 seconds -press RETURN or Esc.to abort and enter prom.
Startup Menu
[1] Download Software
[2] Erase Flash File
[3] Password Recovery Procedure
[4] Enter Diagnostic Mode
[5] Set Terminal Baud-Rate
[6] Stack menu
[7] License menu
[8] Back