Baracoda DualRunners – User Guide v1.7 - 8 -
Data Capture
for Workforce
in Motion
2. PDA stylus
In order to attach the PDA stylus to the DualRunners, insert the stylus into the hole, as showed in Fig.1. Note
that there are two holes, symmetric around the principal axe of DualRunners. Push downwards, as shown by
the arrow n° 2 in Fig.1 till you will hear a clips.
There are two holes, one on both sides.
Note: You will not be able to use the Protective boot and the PDA stylus simultaneously.
3. Recharging the battery
Recharge the internal battery by using the included AC adapter or the charging cradle (optional). The Adapter
rating is 5V, 500mA.
When the product is charging, the RSL led (left) has the following status: one single long blink red + green
(solid).
When the scanner is fully charged, the RSL led (left) is green (solid).
A full recharge (from completely drained batteries) takes approximately four (4) hours.
When the original batteries wear out, please contact your Baracoda reseller for replacements.
Note: When you insert the DualRunners (with its protective boot) in its charging cradle, the scanner will:
- emit a beep.
- and automatically switch on (if it was off).
Fig.1
