KM0832 User Manual
42
IP Installer Setting
You can use the IP Installer to view and change network settings for the
KM0832. The IP Installer can be downloaded from our Website.
Click Enabled to allow the IP Installer to be used to change the IP
address, subnet mask, and gateway for the KM0832.
Click View Only to allow the IP Installer to be used to view the IP
address, subnet mask, and gateway for the KM0832.
Click Disabled to restrict the IP Installer from being used to view or
change the network settings for the KM0832.
IP Address
You can either manually enter a static IP address or use a DHCP server to
dynamically assign one. If you enable a DHCP server to assign an IP address
to the KM0832, we recommend that you configure the KM0832 to send an
e-mail notification if the IP address changes. See System Event Reports,
page 43.
To use a DHCP server to assign an IP address:
Under DHCP Enabled, click Yes.
To manually assign an IP address:
1. Under DHCP Enabled, click No.
2. Under Manual IP Address, enter the IP address, subnet mask, default
gateway, and primary DNS server. You also can enter an alternate DNS
server; however, it is not required.
Port Settings
Enter the network ports that the KM0832 will use to transfer Webpages and
communicate with client programs. Typically, port 80 is used for Hyper Text
Transfer Protocol (HTTP) communications, while port 443 is used for HTTP
over Secure Socket Layer (HTTPS). Failure to assign a port for each field will
cause the KM0832 Administrator Utility to function incorrectly.
