KM0832 User Manual
120
(Continued from previous page.)
Pausing and exiting are the two ways to stop scanning and keep the
focus on a particular KVM port. If you intend to continue scanning
after a brief stop, pausing is more convenient than exiting Auto Scan
mode completely because when you resume scanning after pausing,
you start from where you left off. On the other hand, if you exit and
then restart Auto Scan mode, you start over from the very first KVM
port on the installation.
To resume Auto Scanning after you pause, press any key or left-click.
Scanning continues from where it left off.
While you are in Auto Scan mode, you can press the arrow keys to skip
through the OSD list:
After the amount of time set with the SCAN INTERVAL elapses, Auto
Scan mode will switch to the next KVM port.
When you skip, you only skip to the previous or next available KVM
port that is in the Auto Scan mode selection (see page 101).
While Auto Scan mode is in effect, ordinary keyboard and mouse
functions are suspended
—only Auto Scan mode compliant keystrokes
and mouse clicks can be input. You must exit Auto Scan mode in order
to regain normal control of the KVM console.
3. To exit Auto Scan mode press [Esc] or [Spacebar]. Auto Scanning stops
when you exit Auto Scan mode.
←
Switches to the previous KVM port in the OSD list.
→
Switches to the next KVM port in the OSD list.
↑
Switches to the first KVM port in the OSD list.
↓
Switches to the last KVM port in the OSD list.
