1152700 • Issue 1 • February 2001 • Section 2 Operations and Maintenance
Page 2-61
© 2000, ADC Telecommunications, Inc.
DLP-703
Page 1 of 2
LOGON TO REMOTE NODE CRAFT SESSION
VIA TELNET FROM GUI
Summary: This procedure instructs the operator in the steps required to logon to an NE through
the craft session from the NMIC Cellworx Vision GUI. Once logged onto the NE craft screen,
the operator can provision all cards, ports, and alarms for that shelf. The provisioning
information is set on the shelf controllers and backed up onto the NMIC immediately following
the change. Prerequisites to this procedure requires that the operator must first have launched the
GUI that controls the node targeted for craft interface session, and the node must have been
discovered and is visible to the NMIC.
1. To establish a craft session to a node from the GUI, select the Direct Selection tool (arrow)
on the left tool bar using the left mouse button. Next select the targeted NE and then hit the
right mouse button. A pop-up menu appears. See Figure 703-1. Select Craft Interface.
2. The targeted node responds with a logon screen prompting the operator for a user name and
password. See Figure 703-2. If this is the first time the node had been logged onto, the
default name and password should be “cellworx” and “cellworx#1”. If this is an existing
network, the defaults should have been deleted and unique name and password entered. If
you are not sure of the new user name and password for this node, check with your network
administrator.
3. The Cellworx main menu should now be displayed resembling the example shown in
Figure 703-3.
Stop! You have completed this procedure.
Cellworx Vision Subnetwork Management System
File Configuration Fault Performance Help
i
GNE-1
NE-2
NE-3
10942-F
Craft Interface...
Create Connection...
View Connection...
Configure Alarm Threshold...
About...
Reflash Boot Image
Configure Software...
Cellworx User: root
Local Time: 23:30 GMT Time: 23:30
Figure 703-1. GUI Remote Craft Logon Pop-up Window
