Installing the PathBuilder S21x Switch Hardware 2-1
Chapter 2
Installing the PathBuilder S21x Switch Hardware
Overview
Introduction
This chapter covers the installation of PathBuilder S21x switch hardware.
Follow These Steps
This table lists the steps you need to perform and shows you where to look for
information on installing the PathBuilder S21x switch:
Warning
The following special notices apply to all equipment handling procedures in this
manual.
Warning
Ports capable of connecting to ports on other apparatus are defined as Safety Extra
Low Voltage (SELV). To conform with EN60950, ensure that these ports are only
connected to ports of the same type on other apparatus.
Avertissement
Les ports qui sont susceptibles d’être connectés à des équipements sont désignés
comme TBTS. Pour garantir la conformité à la norme EN 60950, n’interconnecte
ces ports qu’avec des ports du même type sur des autres matériels.
Warnung
Anschlusse, die mit anderen Geraten verbindet werden konnen, sind als SELV
beschrieben. Um Konformitat mit EN 60950 zu versichern, sichern Sie es, daß diese
Anschlusse nur mit den des selben Type auf anderen Geraten verbindet werden.
Step To Perform This Action See This Procedure
1
Check the contents of the
shipping package to make sure
everything is included.
“Checking Your Shipment Contents”
section on page 2-2.
2
Choose a site for the Path-
Builder S21x switch.
“Choosing a Site” section on page 2-3.
3
Connect cables for the Path-
Builder S21x switch.
“Cabling the PathBuilder S21x Switch”
section on page 2-5.
4
Set the front panel dip switches
if required.
“Front Panel Dip Switches” section on
page 2-10
5
Installing Optional Daughter-
card.
“Installing Optional Daughtercards”
section on page 2-11
6
Installing or Removing the Lith-
ium Battery
“Installing or Removing the Lithium
Battery” section on page 2-12
