Integrated Fast Setup
63
In PNNI mode, this section is not relevant and an appropriate message is
displayed.
FastBUS Configuration Section
This section prompts you to
configure the FastBUS module. If no FastBUS module is installed, this
section is skipped by the Integrated Fast Setup.
To configure the FastBUS:
1
At the prompt, enter
1
to enable the FastBUS module or enter
0
to
disable it.
2
At the prompt, enter a number in the range
1-4
to select the capacity of
Bank 1 from the list of four possibilities:
Options: 1-6*10MB/s
2-3*20MB/s
3-2*30MB/s
4-1*60MB/s
The factory default is 4.
Your choice is displayed.
3
As in step 2, select the capacity of Bank 2.
4
For each of the 16 resident ELANs, enter a number in the range
0-2
to
select the bank assignment for the ELAN from the list of three
possibilities:
Options: 0 - Conventional
1 - Bank 1 (1*60MB/s)
2 - Bank 2 (1*60MB/s)
The factory default is 0.
Your choices are displayed.
The following is an example of the FastBUS configuration.
LECS Address
--=---------
Active LECS addr:47.00.00.00.00.00.3c.00.00.a0.00.00.00.00.a0.3e.00.00.01.00
