Filter
Top Products
Revision A
GoodKnight 420G - Patient Manual 15
In this case, the display again shows one of the following two screens indicating the status of your
device (the values are given as examples).
17:34
8.0
cmH
2
O
1
The device is on standby.
The device is running.
NOTE
Exit from the parameter setting menu takes place automatically when you do not press any key for 30
seconds.
Setting the time
You can set the time only when the device is on standby. To do so, just press the Ramp button for one
second. (See reference 3 in Figure 2, page 5). Then while continuing to hold the Ramp button down,
press the ON/OFF button. (See reference 4 in Figure 2, page 5). If you release the pressure on the
buttons, the symbol of adjustment
appears under the hour, as shown on the screen hereafter:
13:13
h
NOTE
The time will only be displayed in a 24-hour format. Thus, 13:13 represents 1:13 P.M.
The letter h indicating the hour blinks, you can then set it using the Ramp and ON/OFF keys.
To set the minutes, just press the Information Access button, the symbol of minutes blinks in its turn
and you can set them by following the same procedure as for the hour.
Press the Information Access button again to exit the menu.
NOTE
Exit from the parameter setting menu takes place automatically when you do not press any key for 30
seconds.